India, with an energy-guzzling economy growing at a fast rate, has approved a proposal to declare electricity generated from oceans as renewable energy.
The approval was accorded by Power Minister Raj Kumar Singh on Thursday, the Ministry of New and Renewable Energy (MNRE) said in a statement.
Energy produced using various forms of ocean energy such as tidal, wave, current and ocean thermal energy conversion would be considered as renewable energy and will be eligible for meeting the non-solar Renewable Purchase Obligations (RPO).
Oceans cover 70 percent of the earth’s surface and represent an enormous amount of energy in the form of wave, tide, marine current and thermal gradient.
India has a long coastline with the estuaries and gulfs and a theoretical ocean thermal energy potential of 180,000 MW of various forms of ocean energy, the MNRE said.
A background paper circulated by the MNRE says a variety of different technologies are currently under development throughout the world to harness this energy in all its forms. Deployment is currently limited but the sector has the potential to grow, fueling economic growth, reduction of carbon footprint and creating jobs not only along the coasts but also inland along its supply chains.
As Indian government steps up its effort to reach the objectives to contemplate its renewable energy and climate change objectives post 2022, it is opportune to explore all possible avenues to stimulate innovation, create economic growth and new jobs as well as to reduce the carbon footprint of India, one of the world’s biggest emitters of greenhouse gas.
Most types of technologies for tapping ocean energy are currently at the initial stage of commercialization. The MNRE intends to support demonstration projects of proven technologies and as approved by expert committee constituted by the Ministry.
Total identified potential of tidal energy is about 12,455 MW, with potential locations identified at Khambat and Kutch regions of Gujarat on the coast of the Arabian Sea and large backwaters where barrage technology could be used.
According to preliminary estimates, the total theoretical potential of wave energy in India along the country’s coast is estimated to be about 40,000 MW, the Ministry said.
The ocean tidal cycle occurs every 12 hours due to the gravitational force of the moon and the difference in water height from low tide and high tide is potential energy.
Similar to traditional hydropower generated from dams, tidal water can be captured in a barrage across an estuary during high tide and forced through a hydro-turbine during low tide, according to the Ministry.
However, the capital cost for tidal energy power plants is very high due to high civil construction and high power purchase tariff. To capture sufficient power from tidal energy potential, the height of high tide must be at least five meters (16 feet) greater than low tide.
The Gulf of Cambay and the Gulf of Kutch in Gujarat on the west coast have the locations in the country where potential exists.
Wave energy is generated by the movement of a device either floating on the surface of the ocean or moored to the ocean floor. Wave conversion devices that float on the surface have joints hinged together that bend with the waves. This kinetic energy pumps fluid through turbines and creates electric power.
Stationary wave energy conversion devices use pressure fluctuations produced in long tubes from the waves swelling up and down. This bobbing motion drives a turbine when critical pressure is reached, the Ministry said adding other stationary platforms capture water from waves on their platforms. This water is allowed to runoff through narrow pipes that flow through a typical hydraulic turbine.
Marine current is ocean water moving in one direction known as Gulf Stream. Tides also create currents that flow in two directions. Kinetic energy can be captured from the Gulf Stream and other tidal currents with submerged turbines that are very similar in appearance to miniature wind turbines.
Similar to wind turbines, the movement of the marine current moves the rotor blades to generate electric power.
Ocean thermal energy conversion uses ocean temperature differences from the surface to depths lower than 1,000 meters, to extract energy. A temperature difference of only 20°C can yield usable energy.
Research focuses on two types of OTEC technologies to extract thermal energy and convert it to electric power: closed cycle and open cycle. In the closed cycle method, a working fluid, such as ammonia, is pumped through a heat exchanger and vaporized. This vaporized steam runs a turbine. The cold water found at the depths of the ocean condenses the vapor back to a fluid where it returns to the heat exchanger. In the open cycle system, the warm surface water is pressurized in a vacuum chamber and converted to steam to run the turbine. The steam is then condensed using cold ocean water from lower depths.
